You’re about to embark on the first adventure in your new RV, and your feelings of excitement are through the roof. Though in the back of your mind you can feel just a little bit of anxiety and nerves, mainly because you’ve never pulled into a campground with your new rig, not to mention hooked it up to everything.

Since there are only two RV spots available, it is very private. Rent is $800 for 4 weeks (minimum) for one site and, if you rent the 2nd RV site, the rent goes down to $700 for each site. Must have vehicle and RV insurance and rent is to be paid in advance. A full hookup campsite is a site that will have access to all the amenities to hook to your motorhome or travel trailer. These amenities include a hookup for your water lines, a hookup for your electricity. This will include a 50 amp service, 30 amp service or both. Also, there is usually at least one 110v plug. 29 full-hookup sites for RV’s up to 28 feet long. 50 full-hookup sites for RVs up to 50 feet long. California Death Valley National Park. Furnace Creek: 18 full-hookup sites. Max RV size: 36’ Stovepipe Wells: 14 full-hookup sites: Maximum RV size: 60’ Panamint Springs: 6 full-hookup sites: Maximum RV size: 60’. Family Camping at Dakota Campground: full hookup RV sites that are wide, level, pull-thru, 30/50 amps in Walsenburg a 1/2 mile off I-25. On-Site BIRCO RV Services with full time mechanics to fix your RV. Lathrop State Park. 3 miles west Walsenburg, COLORADO'S FIRST STATE PARK, Lathrop offers views of the Spanish Peaks.

Above is exactly how I felt before our first trip, I knew everything would work out but at the same time I had no idea what I was doing.

Rest easy, because below we’re going to discuss what you need to know before your first trip in regards to your RV hookups. Let me tell you from experience, it’s not going to be nearly as difficult as your mind would lead you to believe.

Cost to Install RV Hookups on Land. First, let’s talk about money. The cost to install RV hookups on land can vary quite a bit. In the end, the total will depend on 1) how much work you’re able and willing to do on your own, 2) how many amps your RV requires, 3) the type of sewer system you’re working with, and 4) how far from your house you’d like your hookups to be.

The first thing I do when I pull into our new spot is make sure our RV is leveled out and secured. I also get the slide-outs pulled out, if you don’t have slide-outs no need to worry about this. Our slide-outs aren’t located near our hookups, but if yours are then you may want to pull them out after you get everything hooked up. Use your best judgement for this and you’ll be just fine.

Hooking up power to your RV

The first thing I do is look at the power supply box.

As you can see from the picture above, this campground has both 50 and 20-amp service. A lot of campgrounds, especially State Parks have 30-amp service.

How to tell the difference between different amp options

50-amp plug-ins have 3 flat prongs and 1 round prong. 30-amp plug-ins have 2 flat angled prongs and 1 round prong. 20-amp plug-ins are your standard house plug-in with 2 straight flat prongs and 1 round prong.

Here is an example of the female plug-in for 50-amp:

This is an example of the male plug-in for 30-amp:

Now that the types of connections have been established you need to decide which version you have. For this campground we have 50-amp service, because our main hookup is 50-amp we’ll be connecting this way. When we run into campgrounds that only offer 30-amp service we use a step down adaptor (or dog bone), which allows us to convert our RV’s 50-amp connection into a 30-amp connection. You can see what that looks like below:

At this point you know which power you have and which power the campground has so it’s time to get connected using the correct plug-in.

The first thing you’ll want to do is cut the power to the power supply box you’re going to be connecting to. Most campgrounds have a breaker switch right in the box where you’ll be connecting. With the power turned off you can go ahead and plug your rig into the power supply.

After making sure you have securely connected the plug you can flip the breaker switch back to the on position.

Now you have power!

Hooking up water to your RV

Now it’s time to get the water flowing through your rig.

You’ll want to grab your fresh water drinking hose. It’s important when hooking the water up to your RV that you make sure your hose specifies it’s for drinking water.

Next you’ll want to grab your water pressure regulator. The main reason to use a water pressure regulator is to ensure the water isn’t coming into your system too fast, otherwise it can create problems for your system, which we don’t want.

This is the one we use, though there are a ton of options out there. You’ll need to do a little research to decide which is best for you.

The next piece you’ll need to grab is your water filter. While this isn’t mandatory, we’ve found it helps get rid of contaminates.

Now you have all the pieces you’ll need to hook your water up. I’ve seen many different setups as far as where to plug up the water regulator and filter, so I recommend doing research to determine which way works best for you. Below are a couple photos showing how we connect our water.

It’s important to make sure your water system is set to City Water and not your water tank, and that your water pump is turned off while you’re connected to City Water.

Boom! You’re now connected to power and water.

Hooking up cable to your RV

Cable hook up works the exact same as if you were connecting your cable box up at home.

If your campground provides cable access you need to grab your coaxial cable and connect one end to the cable supply and the other into your rig.

That was pretty easy right?

Now that we have cable, water, and electric hooked up it’s time to connect to sewer.

Hooking up sewer to your RV

Provided the RV spot you’re staying at offers sewer connections, here’s how to get it connected.

First things first, put on some gloves. I have a little box of disposable gloves I keep in the sewer compartment, though I’ve seen many people use gloves they can wash and reuse. I’ve never noticed any “contaminates” on my gloves, but it’s better to be safe than sorry.

Now that you have gloves on it’s time to check your grey and black tank pulls to make sure they’re closed, then grab your sewer hose.

Using the open end of the hose with the twist-on connector attach it to your RV drain spout.

At this stage I like to grab my sewer hose support and run it from where I’ve attached the end of my hose to the RV all the way to the sewer drain. As I run the support I’ll place the hose in place.

At the end of your hose you’ll need to attach your elbow that connects to the sewer drain then put it in place.

If you look at the elbow above, you can see it sits well into the sewer drain. It actually has threads on it so you can generally screw it into position which ensures it doesn’t come flying out when you drain the tanks. If the sewer drain has threads you’ll want to use them, some places don’t, so keep that in mind.

But overall that’s it.

Not too bad right?

As you go through this process a few times you’re going to learn approaches that you like and dislike. So roll with the punches, learn as you go, and remember your RV was made for fun so try to make the best of all aspects of RV life, including hooking up your sewer.

If you want to get the most out of your RV will come to rely on hookups; water, sewer and electric. Taking full advantage of these while traveling in your RV will bring a high level of comfort regardless of your destination or stopovers. Each of these three hookups allows you to enjoy at-home comforts while you are on the road. They are found at most RV parks and campsite, but you should know that they are not free. You will have to pay a higher per site price to use these hookups. To many, this is more than worth it. Some sites have partial hookups that allow you to pay for only what you use.

Water Hookups

These will give you access to running water no matter where you are. Many of the appliances and features of your RV will require water such as the toilets and sinks. With a water hookup you can drink tap water so save on bringing water bottles and you don’t have to search endlessly for a public bathroom. Once you are parked, this is the first hookup you will want to connect to. Not all parks require the use of a water pressure regulator, so be sure to find that out first.

B sure to unwind your hose completely to remove all kinks before connecting to the RV. Once secure, connect to the hookup and turn on both the water and gray tank valve. Always check for leaks at both ends. When it is time to disconnect, turn off the water supply, shake the hose to remove any lingering water and disconnect from the water source first, and then your RV. To use your shower, do dishes, and flush the toilet, you want to be sure you find an RV park with a water hookup.

Sewer Hookups

Rv Park Hookups Inc

If you are using water hookups, you also want to use sewer hookups too, so you can dispose of any running water. You have a black tank which holds waste from your toilet and a gray tank which disposes of water that doesn’t contain waste. You never want your black tank to be over 75% full and you will never have to worry about this with a sewer hookup.

You need a sperate hose to the water hookup and this will be done after connecting the water. Attach the hose to the hookup first and then your RV. You can open the black tank valve as soon as the hose is secured. To disconnect, you want to always wear gloves because it can get messy. Turn off all valves and disconnect from the RV, holding the hose upright. This will allow waste to flow back down the hose into the sewer system. Always wash the hose with waste-fighting chemicals before storing it.

Electrical Hookups

This allows you to power up the RV’s electrical system so you can use heat, lights, AC, and appliances. Most parks and campsites offer 30 and 50-amp hookups. Most likely your RV is set up with one of these two options. Smaller RVs are set up with 30AMP hookups, larger ones with 50. These will be the last hookups you make once settled into your location.

Rv Campgrounds With Full Hookups

You must make sure the hookup box matches what your RV can handle, because many older sites are not equipped with up to date systems. Double check first to avoid blowing the entire electrical system. Hook both ends of the cable up, turn on the regulator switch, and you have lights, power, and action. To disconnect, turn the regulator off and unplug the cable connected to the RV first, then the power source.

Rv Hookup Camping California

Remember that not all campgrounds and RV parks will offer hookups, so you want to research ahead of time. You can plan your stops accordingly. These hookups allow the comforts of home to be with you while you travel. The staff at the sites are always more than welcome to assist you with questions and connections. Add the comforts you are used to and make your trip special and your RV a home away from home.